PVC build by dkl

Classic Goldwings

Help Support Classic Goldwings:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Status
Not open for further replies.

dkl

Well-known member
Joined
Aug 1, 2012
Messages
258
Reaction score
0
Location
LOUISIANA
*Complete instructions for PVC Manifold*
This is the fitting list and a Pictorial on my PVC Manifold for the GL1100 with a VW34-3 carb. It runs great and I have put 3,000 miles on this set-up. Cheap and easy to build set-up to get a GL1100 with trashed carbs back on the road.

4 -pieces 1" sch 40 Flex PVC. regular flex.....found on Flex PVC website.
2 -regular 1" PVC sch 40 45 ELLs
2 -short 1" PVC sch 40 45 ELLs
4 -PVC 1 1/4 x 1" sch 40 PVC Bushings Glue Fittings
1 -PVC Sch 80 1" Floor Flange Glue Fitting
1 -PVC 1" 5 Way Cross
1 -PVC 1" short piece of PVC pipe to cut short pieces to join fittings together.
1 -Small Piece 1x4 Lumber to place under cross, it rests on coolant tubes and supports weight of carb. I glue rubber on top of board.

I marked where the fittings should be cut, but different brands are different lengths, measure twice-cut once.

image.php


image.php


image.php


image.php
 
Status
Not open for further replies.

Latest posts

Top