1984 1200 install into 83I

Classic Goldwings

Help Support Classic Goldwings:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

dan filipi

Well-known member
Staff member
Administrator
Moderator
Supporting Member
Joined
Dec 3, 2009
Messages
22,400
Reaction score
236
Location
Van Nuys Ca.
My Bike Models
1983 Interstate
2018 KLR 650
2018 BMW S1000 RR
My Bike Logs forum link
https://classicgoldwings.com/forums/dan-filipi.122/
Installed engine early 2015 at approx 13,500 miles on bike.

Pulled big rear cover to inspect stator. Looked near new condition

Used a 83 rear clutch cover on the big 84 rear cover for mechanical clutch instead of hydro.

Clutch plates pack not opened up to inspect. Needed to compress pack but too lazy at the time.

Installed near new water pump from the 1100 motor. Old one was bakelite with loose bearing.

New timing belts.

Installed single carb manifold and modded in coolant fittings to motor for heat plate.

Fresh oil and filter.

Opened starter, fairly clean and brushes looked good.
 
Top