• If you have bought, sold or gained information from our Classifieds, please donate to Classic Gold Wing and give back.

    You can become a Supporting Member or just click here to donate.

GL1100 Single Carb & Floorboards

Classic Goldwings

Help Support Classic Goldwings:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

wedoo2

Well-known member
Joined
Oct 18, 2015
Messages
726
Reaction score
0
Location
Terre Haute, IN
I have a couple of items that are for sale. First are the floorboards that fit the GL1100. I don't like them so out they go. $25. Chrome and rubber pads are just fine with just a bit of corroded chrome on the sides.

The carb set up is the Solex unit with an air filter. I was going to use it but with all of the other obstacles I've had I don't want to deal with it. The manifolds are already measured, (and they fit the 1100 perfectly). I have nearly $150 in this and will take $75. If you have considered going to a SCC it won't get easier, or cheaper for new stuff.

IMG_0321_zpsi432avml.jpg


IMG_0320_zps1tvhdelz.jpg


IMG_0318_zpsxq1j4tag.jpg


The floorboards are not red, it is the reflection off the umbrella. I think they are BMS units.
 
That's a good deal on the carb/manifold. I wish that would have been available a couple weeks ago. I have about $110 in a similar setup. Somebody needs to jump on this!
 
[url=https://classicgoldwings.com/forum/viewtopic.php?p=179356#p179356:2d2b5vp4 said:
rock42 » Yesterday, 4:57 pm[/url]":2d2b5vp4]
i would like the floor boards for my 82 1100i

Want me to put you down for them Rock?
 
[url=https://classicgoldwings.com/forum/viewtopic.php?p=179388#p179388:115j2lcc said:
PurpleGL1200I » Fri Aug 26, 2016 8:56 am[/url]":115j2lcc]
Any chance the carb/manifold would fit a 1200?
It should fit a 1200 with 1100 intake horns to get the correct angle. 1200 is only about 1/4" wider than an 1100.
 
It might go, but iffy since there isn't much clamping surface at the horns to start with.
I tried a Cycle Innovations manifold that fits an 1100 tight but barely clamps in with horns moved to the 1200. I didn't feel comfortable with it to seal.
 
[url=https://www.classicgoldwings.com/forum/viewtopic.php?p=179396#p179396:21hn89fa said:
slabghost » 22 minutes ago[/url]":21hn89fa]
PVC manifold should be easy to widen.
True. Couplings on the runners done deal. I might buy if nobody beats me to it.
 
Boy the carb and manifold is very tempting (and a great price!). But I will have to (very reluctantly) pass. I have to keep my dollars dedicated to the wire harness project. :crying:
 
PM, belatedly, sent to Rock. If I have passed the opportunity with Rock then I will let everyone know. Otherwise the floorboards are sold.

I have sold the SCC set up as well. I appreciate the responses.
 
Top