Stevej's wing
Well-known member
Does anyone in this forum have any good ideas to install a case unto new rings. Piston holder or just fumble around in case and cross your fingers the rings slide into the bore at the bevel without breaking.
I watched that before I joined the cases on my 1200 but didn't find it very informative. That video is called "joining the cases" but just shows piston covered by rags, that apparently have ring compressors on them, and then the cases are joined and we hear that it went pretty well.[url=https://classicgoldwings.com/forum/viewtopic.php?p=188693#p188693:3rvg7wtk said:joedrum » Fri Mar 31, 2017 6:17 pm[/url]":3rvg7wtk]
read this thread and there videos in there too
viewtopic.php?f=22&t=10690
Enter your email address to join: