wedoo2
Well-known member
I recently put in a new stereo head unit and am now going to install an amp to boost things. I have a Kenwood KAC-M3004 amp, 600 watts. I had, in full disclosure, almost ruined the thing a while back when the battery lead touched the negative and pretty much burned all the wires in what I thought might burn up the bike and my garage. Quick work yanking the battery connection saved my arse.
At any rate all is fine now after sending the amp to Kenwood and them replacing something. It works now. Radio itself is fine and I am jammin.
My question concerns the controls/settings on the amp. There are Filter Frequency controls; High pass (HPF) and Low pass (LPF) filter positions and at this point they are set to off. There is an Input Sensitivity as well and I have no idea what any of these things mean.
Any enlightenment would be helpful. Could be that I don't need any filtering at all??? Here's a picture of the controls
At any rate all is fine now after sending the amp to Kenwood and them replacing something. It works now. Radio itself is fine and I am jammin.
My question concerns the controls/settings on the amp. There are Filter Frequency controls; High pass (HPF) and Low pass (LPF) filter positions and at this point they are set to off. There is an Input Sensitivity as well and I have no idea what any of these things mean.
Any enlightenment would be helpful. Could be that I don't need any filtering at all??? Here's a picture of the controls