set the accelerator pump to minimum stroke and its still bogs down unless i just barely advance the throttle, over Thanksgiving weekend Im gonna disconnect the accel pump and see what happens.
Dialed back the pump stroke to about 25% was set at 50. Still bogs down a bit when I hit the throttle. Gonna set it to minimum stroke and see what happens
If I have time this weekend I"m gonna pull the fan switch on my bike and check it, the switch functioned for the first couple of weeks after I bought my bike but then stopped, bypassed the switch to verify the fan worked so its definitely the switch. And since the dealer wants $130 for a new...
Ok got the 125 jet and installed. Mileage is running about 32-33 mpg. Throttling still sluggish. May do Dan's suggestion and disconnect the accelerator pump and see if that makes a difference. If it doesn't I have the rebuild kit for the Holley and will reinstall it with the CI manifold. I did...
Ordered up a 125 jet still want to play with the accelerator pump, just don't have the time right now for tweaking and testing so I'm just gonna do the jet upsize for now and hope that takes care of the uphill problems
OK I've had the 122 jet in for a couple of days, put a couple hundred miles on, and I'm getting about 34mpg. Still a bit sluggish on uphill acceleration though, may bump the jet size up to 124
Well so far so good did a couple uphill starts on the way to the ferry with no stutter, once I get off on the other side I can open it up on the highway and see how it goes.
Ok got my jets on Friday put in the 112 couldn't get above 45 mph, pulled that put in the 120, much much better but acceleration lags past 60 and hills it drops off and hard to maintain speed, so gonna try to put the 122 in during my lunch break and see how it goes on my trip home
used the calipers at work to measure the tip cleaner and it came out to 1.25mm. So allowing for play its probably the 127.5. So what size should I drop it to?
Well I found a 1 on the jet rest was obscured. However sizing with a welding tip cleaner( assuming smaller # means bigger cleaner it was a size 8 (or 22 if its vice versa) just need to convert that to an actual measurement and translate into a jet size