Alright I pretty much have the plan created for what goes where, what gets plugged and whatnot on my Weber 5740 (AKA 32dft) But I ran in to one thing I can't figure out. So in this picture there is a larger nipple on the middle right side. Its below the fuel inlet. I can't figure out what it is. I think it might be a bowl overflow release, but honestly not sure.
If its the bowl overflow should I cap it, or run a length of fuel hose from it to the bottom of the bike (so fuel would be dumped on ground instead of on heads. Or.....
If its the bowl overflow should I cap it, or run a length of fuel hose from it to the bottom of the bike (so fuel would be dumped on ground instead of on heads. Or.....