pidjones's latest activity

Classic Goldwings

Help Support Classic Goldwings:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  • pidjones
    pidjones replied to the thread what did you do today.
    Results of the scan are no metastatic disease (in the bones).
  • pidjones
    pidjones replied to the thread what did you do today.
    Had a bone scan done. That wasted the morning. Plan to ride the Spyder in to Twisters later to see what everyone is riding and enjoy...
  • pidjones
    Choke partially on, exhaust collapse (they are double-wall, I recall hearing of one with just the inner wall collapsed).
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Work on this project will be put on hold for a while. I need a couple surgeries, and recovery/rehab will take a while.
  • pidjones
    Well, the coolant thermostat should close below ~185 F and open at about 190 F. Fan or no fan. Of course, with no fan and to motion...
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Unorthodox, that's me. Trying to figure out a very shallow ramp to take it out the garage to the drive out back. There is about a 1.5"...
  • pidjones
    pidjones reacted to Daeouse's post in the thread 75 GL1000 "Pete" with Like Like.
    Unorthodox, but effective.
  • pidjones
    pidjones reacted to Daeouse's post in the thread what did you do today with Like Like.
    Took the wheels off the Wing to get new tires put on!
  • pidjones
    pidjones replied to the thread what did you do today.
    Needle biopsy on the man gland. Ouch. Won't be riding for a few weeks.
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Head mounted and torqued, belts mounted with new idlers, valves adjusted, valve covers installed. Rolled it over upside-down on a...
  • pidjones
    pidjones replied to the thread Oil filters for synthetic oil.
    Gimmick.
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Well, I have the new head gasket in hand. And ONE of the idler bearings. I had ordered two at the same time from Amazon, but one came...
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Spent over five hours today getting the head gasket cement off of the head and block. They even used whatever they used on the head...
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Pulled the left head today. There was just a bit of "mud" in the #4 cylinder, which wiped right out leaving nice looking walls. Turned...
  • pidjones
    pidjones replied to the thread 75 GL1000 "Pete".
    Finally feeling good enough to tackle this thing again. Will probably pay for it tomorrow, but the shoulder just isn't improving, so...
    • shazbott1.jpg
    • shazbott2.jpg
Top