Search results

Anybody out there I need to know the shock spring and fork spring part numbers for gl1200. Also can anybody know how to tell the difference between stock and progressive springs. Thank you.

found a place that sells diaphragms for wings I am not a friend or foe just a place on line for carb diaph. www.carburetordiaphragms.com

I keep reading to make sure the return hole on the clutch master is open question where is it? It says it small the only hole I can find is rather large.

Is there a brass piece of metal inside the master shaped like a figure 8 one end smaller with a hole through both ends with tangs at a 90 degree angle. there is this part on my bench were I was overhauling it. Please respond cant find it in Honda manual.

8 /26 Bought bike 8/31 trailered home 9/1 started ordering parts wheel master cylinder 9/2 started tearing apart Tupperware and rear wheel rebuilt rear master cylinder, removed final drive flushed and cleaned , removed fuel tank let soak with rust remover for 24 hrs turning often. Checked wheel...

can't find article on anti dive unit maint. Anybody seen one? where to find it. :rtfm:

How long do I charge this new battery to try to get long life out of it and charge at how many amps for how long. Thanks

Please help I seem to have turned my new to me 86 aspy into a boat anchor. Was replacing my crash bars had one bolt in and was pivot bar accidently came into contact with positive side of batt. A few sparks but didn't pay attention to anything being wrong. Went to start bike nothing. No power...

I can"t find any articles or video on the site to guide the process of removing and replacing valve seals on a 86 1200readi. Is this the same as 1100? I need one without taking off the heads . I was reading an article that mentioned doing so but that was the limit of the article. I hope it an...

I keep reading in the forums about disabling the 2ndary air system on the carbs. What benefits does this serve?

sorry to have to ask a question already. I tried to sync. my carbs today can get 1-2-4 to sync to 16hg but #3 is at 41hg. Does anybody have any idea what is wrong have tried everything except pulling and going through #3 again. If anybody has any ideas? Or maybe has seen this before. Thanks for...

Anybody no if floorboards are the same fit between gl1100 and gl 1200 , Thank-you for answers could be expensive mistake

I am the tinman been a tin knocker for over 40 years and a pretty good welder. I also tried my hand at politics and was elected a town judge nut like all good thing they end. I bought a 1986 Aspencade for a winter project [t had been sitting for about 5 years and put away wrong am going through...