HI all
Just done an electric fuel pump conversion. I have set it up so that I can prime the carbs before using the starter motor but I now need to work out how long to leave it in prime mode before the carb bowls are full. I have the flow rate for the pump but need the capacity of the float bowls to finish the calculation. Anyone able to point me in the direction of the answer? (I have seen it somewhere on a forum but just cannot find it now that I need it)
Regards
Just done an electric fuel pump conversion. I have set it up so that I can prime the carbs before using the starter motor but I now need to work out how long to leave it in prime mode before the carb bowls are full. I have the flow rate for the pump but need the capacity of the float bowls to finish the calculation. Anyone able to point me in the direction of the answer? (I have seen it somewhere on a forum but just cannot find it now that I need it)
Regards
