Search results

Finally broke down and replaced ICU with known used one. Solved the issue.

Thanx

Where is the No78 9-pin red connector from kill switch located on my 1985 Aspencade?

Would the resistors only fail when cold? Bike starts no prob if its 20c/ 72F. But not 68F

Full 12v To blk/White wire. Only use kill switch To trigger relay.

Any idea what electrical component works only heater or warmed? My experience they usually fail when heated.

This 6am morning 65F 2 full 400CCA hooked in parallel. Spin like crazy small front spark and no starting. 5pm one battery and fired up instant? What up?

Yes . CCA up To par

Well an update. Last 3 mornings didnt start. Noticed very weak spark from 1/2. Starter right up 3 evenings. Good spark. Dont coils usually fail when hot rather than cool?

Just came back from 3 day campin and die fired right up. Will check again for morning commute.

I have à 85 Gl1200a that almost baver starts.usually just backfires out exhaust. Sometimes it starts though. I have a new full battery ( On charger always). Did the coil power supply mod with relay. Still wont start 3 out of 5 days. I have tryed no choke, 1/2 choke and Still issues. Amy suggestions?

Hi I want To do the direct power supply To ecu/coils. Were is my ecu and 4pin connector blk/wh wires?

Ready for the road.

Hi I had an 1983 Aspencade approx 25yr ago. Just purchased à 1985. Looking here for advice and tips to get Her inspection ready. Thanx