Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="jerryinmich57" data-source="post: 47947" data-attributes="member: 1447">Thanks Dan that's what I wanted was opinions I feel confident with it. :Egyptian:  I made a special lock washer for the pulley I will post a pic of it tomarrow in the Stella topic.Being that the pulley is keyed to the shaft. the washer has a small tang to fit into a small hole in the front of the pulley then once the bolt is tight I will bend the oppisite ( I am pretty sure that is spelled wrong) side of the washer up on to one of the bolt flats. :music: Like the was they used to do it on the front wheel bearings of old cars (when you could adjust them) the tang on them went into a slot on the spindle.JerryThose are some nice looking bolt and prob. worth it if it is out in the open and you need something that strong but too pricey for me too I paid $4.00 at ace hardware for mine.</blockquote>