Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="DadsWing&#039;76" data-source="post: 218976" data-attributes="member: 5730">Some great advice and tip from you all, so THANK YOU VERY MUCH!!SO ...... just a little update.I pulled the carbs, very carefully, in order to not bump them around , incase a float was stuck open.  I rinse out an windshield washer fluid jug and rigged it up as a makeshift fuel tank.  Set it up about 10' above the carbs and ran tubing down to it.  Left it sit for two days, and nothing.  I put some absorbent pads that, when they get wet, they go dark.  After two days, they were still dry.  So I pulled the top slide off of the #3 carb and found the slide was kind of sticking in the cap, it did come out, but I had to wiggle it a bit  not sure if this would have caused a scenario like this, but that's all I found so far.  So at this point, I have contacted someone at Randakks as to when they will have their carb master kits back in stock, as I want to get one on the way to me.  Start there with the rebuild and the see what happens.  I'm at a bit of a loss ...... I was sure hoping to see something to indicate an issue.</blockquote>