Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="joedrum" data-source="post: 111016" data-attributes="member: 98">ok I am sorry guys .. I have completely lost it on pics or video ... I cant get either one to work ...but the progress is quite good ... had to spend 20dollars for hose that would work ... small town nothing available deal ... as it turns out I used all the hose but the bell end ... the runners are cut quite good ... as in fit .. but there was no way to equal the lengths up and fit carb in bike frame without cutting ..the hose I got fit both pieces well .. and on the runners I have 3" plus on each runner ... and all you can get on type 4 also I don't see it leaking with out clamps let alone with them ...it setting right on the center section thermostat housing ....so I am going to make some spacers out pf something to raise it some ..so this is where I am at if I can get video posted I will its kind of hard to see things but its a whole lot better than my typing about it ...sheesh :help:  :whip:  :thank_you:</blockquote>