Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="trat" data-source="post: 149900" data-attributes="member: 4167"><p>Thanks guy's.....I tried heating the carb body and had no luck. If there was away to get a straight shot at the broken needle I could probably get it loose but because there is a slight taper to the needle it has to come out through the threaded end and there is just no way to get any thing on it to push it. The ultra sonic idea may work but I got lucky and found a carb body for this carb, which is carb four, on ebay and scored it for 32 bucks. Hopefully it will be a good enough body to rebuild. so I am down untill next week sometime. If that one is no good I think I know where I can get one but I might have to buy the whole set up to get it! Oh well I am into this bike right so I can spend a little on it and still come out on it. It's a good looking bike it just hasn't run in about 6 years. If it runs good I'll probably just keep it. I need me a good touring bike. My hardtail Sportster is fun but 500 mile days are just a little too hard on this old body on it!</p></blockquote><p></p>