D-50Dave

Have a short update. Have the COP units fitted, not an easy task with the limited space available. The wiring is just about done...

To close the loop on my issue, here's what happened. I brought the bike to Bear's Cycle in IL. Bear specializes in GL's and he rebuilds...

I suggest you pull the valve covers and turn it over by hand to check for sticky valves. I bent a valve with the starter when it stuck...

I picked up this HF tig machine a few years ago for $200. I'm still not good enough with it to use it for a project, but after a...

Is that blue....I think this is blue

Gas pouring out of the carbs on mine , was the plenum oring , carbs probably need a dam good clean and new gaskets , I think the big...

HI stel , not really , they say randaks are the best , I used some parts from K&L kit mainly the gaskets , I had to use the idle jets...

That is a serious box! Man.....toolbox envy! I'm still trying to build up from this. :ROFLMAO: :ROFLMAO: :ROFLMAO: :ROFLMAO:

Havent been able to get the 34 pict to work.i put on a 30/31 and it idles good and revs good.so far,ive only pullled in and out of the...

https://www.ebay.com/itm/404606606720?hash=item5e346edd80%3Ag%3AFEIAAOSwixVlSrXr&amdata=enc%3AAQAIAAAA4J9omN2Oq4jnsUuHeXNQgl8ihYiN%2FjIDZ...

I got a lincoln mig welder, 110v with c25 & argon bottles. It takes care of all my small jobs quite nicely. I think it was about $450...

Can accomplish so much more with the Triumph out of the way. Rear wheel, brake, fender, etc. out and then tank out. Headers and muffler...

If the carbs are clean and well-adjusted, you might want to look at this: How to Cure "Off-Idle" Flat Spot | Randakk's Blog

Would '82s fit? There are 2 pair on Ebay.

Welcome to The Forum and enjoy! You may want to peruse the following for some ideas of what to do...