Nevermind, 1200 Idle adjust/mixture screws

[ekvh]

Is the aluminum puck at 7:00 from the cotter keys on the linkage, the holy grail to pass through to clean and adjust idle???? Shop manual isn't clear to me. If so, drill a small hole and use a sheet metal screw to remove, or do you use the continuum transponder dialexic contrapulation device? Thanks in advance.

I got impatient and pulled one....it's the grail.

 

[joedrum]

well there in there what a pain all this junk is to adjust ...thanks for all the fools in regulation by gov to make something totally junk as end product of there meddling BS

 

[ekvh]

All day for nothing. 1200 set is missing an idle screw. So I tackled the 77 set again, swapped another seat and float into it. So far, no leak. I also drilled the primary main to a 65 jet. Initial run: pretty nice. I hope it's done. Summer is about over. Back to work on the 26th.