Search results

I'm getting older and a trike would be terrific. Anybody got an old rear end? I have an 83 and a 85 Aspencade I could convert.

Honda has discontinued the cooling fan switch and mine is bad. Anybody got a spare I can buy?

Thank you, it truly is a very pleasant ride after I put so much work and parts onto it. I meant to keep it but it's just a little too much for me when it's not moving. I've bought an '83 Honda VT750C with 30k miles and am refurbishing it to be my new ride.

Eaton Rapids Michigan

Here's some pictures.

86 Aspencade. Custom artwork on tank and saddlebags. Full chrome kit. New parts: head gaskets, stator, petcock, timing belts, thermostat, water pump, grips, throttle cables, brake pads, front and rear tires Rebuilt: all 4 carbs thoroughly rebuilt, clutch master and slave cylinders, sight...

I'm using a transmission jack. Pivots and tilts, rolls easy any direction. Of course I'm a 1st timer at pulling a goldwing engine out but it went smoothly.

The company that sold the defective part is ignoring me so I'm on my own. I got this bike from a friend after the head gaskets started leaking. I replaced the top end gaskets and seals and all associated o-rings. Also I replaced the water pump, timing belts and thermostat. While doing all...

Who's had to change a stator on a GL1200? I'm facing this task after an aftermarket part that was wired wrong caused a burnout. Any tips tricks or advice? Does the engine Have to come All the way out? Can it just be loosened up and moved around enough to clear that cover removal? Thank you...

38000 miles and well stored and maintained with custom airbrushed murals and hand laid pinstriping. I got it for $800 leaking antifreeze through the exhaust. While I was "in there" I replaced the head gaskets, water pump (Honda pump), timing belts and thermostat as well as all the associated...

Thank you all for your helpful suggestions. I test rode my '86 GL1200 on Thanksgiving day for the first time. Ran and drove perfectly. I've had to store it for winter but it's ready to go in the spring.

Hello, I look forward to learning from those who've gone before me! I just bent all my valves putting my 86 GL1200 heads on wrong by not paying attention to cam position first. Now I'm paying the penalty for that. Live and learn. I was surprised to see that Honda doesn't make that valve...