using stock throttle cable pulley

[who444444]

has anyone put the stock throttle cable pulley on one of tom's carbs? if so how did you do it?
I have an extra one and was thinking of trying to fit it to carb.
Thanks, dave

 

[dan filipi]

I ground off all but the bell crank and welded the weber carb bracket to the carb side of the bell crank.
There may be easier ways but at the time this worked out well for me.

 

[who444444]

Thanks for reply. If it's easy for you, could you post a pic of it for me sometime?
thanks

 

[HOTT]

Make it look like this...
While you're at it add the cable stop yoke.
I transplant the slotted hole from original throttle
to the back of the pulley.

 

[who444444]

cool, thanks Hott for the pic.
dave

 

[dan filipi]

My welds aren't pretty but they're strong.

I Ground flat the Weber throttle linkage plate then welded it to the back of the GL bell crank.