Help Support Classic Goldwings:
-
-
dan filipi replied to the thread Back Surgery Question.I have no input either other than do what the doctors tell you and take advantage of physical therapy for as long as you can. -
dan filipi replied to the thread GL1000 Timing Issue.Does this help at all? Martek
-
dan filipi replied to the thread Finally crowned.Looks nice, clean!
-
So if you're looking to do a oil pressure gauge mod I have some simple steps for you since there's no information on this and no one...
-
dan filipi reacted to Rednaxs60's post in the thread 1985 GL1200 Limited ECU Replacement/Upgrade - Part 2 with
Like.
Update on the project. Have mentioned most of this in previous posts, just a short recap. Installed the upgraded fuel system... -
This is after the fact but doesn't get mentioned much... The starter gets it's ground from the engine case, and after rebuilding...
-
dan filipi replied to the thread How to replace GL1000 1975 rear master cylinder.I modded in a master from a CBR. Had to make a bracket to extend a mounting hole and get a new brake line made up. Works really well.
-
Ok, I knew for awhile I needed a new ignition switch. Bought one from sabrecycle. Bad choice! I will never buy another part from them...
-
dan filipi replied to the thread Found something… pics coming soon!.Sorry, forgot about the 1200 valve adjusters, a different breed. The rocker center shaft has to be free to rotate so it can adjust the...
-
dan filipi replied to the thread Found something… pics coming soon!.Is that the same engine with the knock in the earlier video? Very surprised it could even run if so.
-
dan filipi replied to the thread Found something… pics coming soon!.Pull heads and replace the bent valves
-
dan filipi replied to the thread Motorycle For Sale 1975 GL1000 For Sale....I didn't count them but have you gotten all the courthouses done or do you have another bike to finish?
-
dan filipi replied to the thread Shaft leak.That looks like grease coming out of the final drive. Mine would do that for a few hundred miles after reassembly and fresh grease. I...
-
Any wires coming off the battery that aren't factory? They may have their own fuse (inline) some where. You could have a wire that has...
-
dan filipi replied to the thread Found something… pics coming soon!.Ive heard that before with one tooth off on the timing belts
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…