PVC Manifold for GL1100 DKL "Instructions"

This is the fitting list and a Pictorial on my PVC Manifold for the GL1100 with a VW34-3 carb. It runs great and I have put 3,000 miles on this set-up. Cheap and easy to build set-up to get a GL1100 with trashed carbs back on the road.

4 -pieces 1" sch 40 Flex PVC. regular flex.....found on Flex PVC website.
2 -regular 1" PVC sch 40 45 ELLs
2 -short 1" PVC sch 40 45 ELLs
4 -PVC 1 1/4 x 1" sch 40 PVC Bushings Glue Fittings
1 -PVC Sch 80 1" Floor Flange Glue Fitting
1 -PVC 1" 5 Way Cross
1 -PVC 1" short piece of PVC pipe to cut short pieces to join fittings together.
1 -Small Piece 1x4 Lumber to place under cross, it rests on coolant tubes and supports weight of carb. I glue rubber on top of board.

That looks great dkl.
:thanks: for posting for others to use and follow.

Sure does, Nice and simple and the tubing is sized right.

AAA

I sure like easy how to projects! Thanks for posting.

:clapping: :thanks:

I'm thinking about building one of these using the 2 to 1 adaptor and run the 2 barrel weber I have.
Where did you get the 5 way?

Flex Pvc website has the 5-way. It is called a furniture grade fitting because it will not pass plumbing code application, but the fitting is full flow schedule 40.