Search results

Just about to send a post to you Steve83, but before I could you had replied - way to go!! Thanks very much most appreciated. I will now order the bearings and hopefully get the old girl back to life. I will just check the actual sizes of Crankshaft to make sure there is no wear.

Still a little confused with how to identify which bearings to order, I think that I need brown for both Conrods and Main bearings. This is what I have found so far can anyone let me know the bearings to get with the information I will post in Pic form. Crankcase II , Conrod 2, Crankshaft B...

Steve83 and AApple, Thank you so much, now makes my life easier, do not have to reinvent the wheel!! Much Appreciated.

Can anyone tell me where the fuel tank rubber is located the part number is 17615-463-000 RUBBER B Some might call it a tank cushion. I have attached the parts view of the fuel tank part no 4. Thanks

GL1100 – 1981 – engine overhaul My story so far:- Bike had sat for quite some time overhauled the carbs and she ran well but had smoke and a small knocking noise when engine cold. Replaced the stem seals better but still smoking on right pipe so decided to do the rings. Opened up the old...

Greetings from Zimbabwe

The post from Steve83 from the manual, puts the subject across very clearly thanks. Where I am so far:- Have taken the engine block and heads to the Engineering shop for an estimate to do the following. Grind Crank big ends to suit bearings as per chart. Standardise conrods. Bore cylinders to...

Thanks, problem is my location and availability of a good repalcement engine. If I was to get one in the States I would have to get it shipped to Zimbabwe extra time and money. I will have to look into the various avenues and weight up the costs I guess. Also could I use any year of GL1100 into...

Belated greetings form Harare, have been a member since 2011 when I got my first new to me GL1100 I 1981. I have had a few posts but found it difficult to get around the site. Anyway better late than never. So Hi. There are not too many Goldwings in Zimbabwe so this site will I am sure give...

Been running my 1981 GL1100 Interstate for a year (bike had been sitting for quite a while and had to recondition the carbs) and it was using quite a bit of oil but bike ran well. I followed ideas on the forum and replaced the stem seals, had a slight improvement but was still using too much...

I will take some picks on Monday but as far as I can see they are original and the Honda part numbers would be 81218-463-770 LOCK ASSY., SIDE BAG 81217-463-770 RUBBER, LOCK

Have a set of saddlebags and Rear trunk and am having difficulty in sourcing original or similar locks for these Hard bags. Can any one help?? need a full set of 6 locks.