Search results

I didn't get to the post office last weekend, but I will make sure I get them out this weekend. Sorry for the delay

This is going to be Well worth it when I'm done ;) I'll be able to say that I did it All Myself with the advise from Here !!!!

WOOHOO !!!! Good day today !! I found the short and Soldered it and heat shrinked it !!!! I tried to drill out the extractor and went through 4 bits LOL !!!! I'll try again tomorrow ;)

Ok, I won the grommets, As soon as I get them in my hand, I'll send a PM for your addy ;)

Well, I am just full of fun news. It was a bad weekend for me and The Ride ..... Started tracing the lines and was just unwrapping electrical tape from everywhere. kept on that all day yesterday until around 4. Needed a break so I was replacing the tach cable and went to put the fuel pump bolt...

I was thinking, When I mounted the new gauges, that's when the power went, Maybe I knocked an ignition wire loose or something ???

Ok, I am completely Frustrated !!!! Again I could not find the main fuse. I bought another ford relay and there is STILL no power. I half want to just get a new harness and start from scratch !!!

I should be winning some and I only need one. If I do I'll PM you for your address.

Hmm, That being said, I will remove the Ford Relay and try to trace all the wires to it.

LOL !!!! Yeah, It's connected ;) I will run my fingers along the wires again and hope I find the fuse !!

is it possible they bypassed it and the relay is now blown ?

LOL !!! Well, I will have to find from the battery through to the starter with the main fuse block and all.

Well, here's another twist, that is Not there !! And it looks like I have a ford starter relay mounted under the gas tank shell !!

I had my 81 running and was installing some New to me parts. New tail light and turn signals and turned the key and they tested fine. I put a new set of gauges on and connected everything up, Turned the key to check and Nothing !!! I disconnected the wires to the gauges and still nothing...

I'm still looking for one if anyone has one. Hats Off to Glider :clapping: He's a stand up guy and said the one he had wasn't working. Thanks For Checking for me !!! Ron

AWESOME !!!

If anyone has a good working rear master cylinder for an 81 standard, I would like to buy it from you. I am watching one on ebay and some guy with a rating of 1 just ran the price way high and there is 2 days left to go still Thanks, Ron

Less Issue and very little performance difference !!! Ok, I'm sold :) Thanks

Great info McGovern61 !! with that, I think I will shy away from the Dual piston setup and look for full single piston replacement system. I'm wanting to get on 2 wheels and enjoy some riding time as soon as possible ;)

Welcome from Florida !!! Nice looking Ride !!