Needed/ gl 1200 used METAL impeller water pumps

[backlander]

In need of a few used gl1200 METAL impeller water pumps, preferably from same person to save on shipping. Pm me with the cost please.

Thanks

 

[Steve83]

Aren't the 1000 and 1100 pumps the same as the 1200's? Might be easier to find. I don't have any - sorry!

Did a parts number cross-reference, and the 1000, 1100, and 1200 all use the same replacement pump. Part # 19200-MG9-681.

 

[backlander]

They will interchange as whole pumps, other than that they are completely different, I'm talking bake lite versus metal impeller, if it's a metal impeller replacement in a 1000 or 1100 I can use it, just not a bake lite. Although it is possible to rebuild a bake lite, the success rate is not that great because the impeller develops hairline cracks and shatters when trying to tear the pump down.

 

[Steve83]

Sorry Mike, I should have stated "replacement" pumps in the 1000 and 1100 are the same. My bad!

 

[backlander]

No prob, here's a pic of the shafts, one on left is bake lite shaft and the one on right is metal impeller shaft. All the internals between the two are different diameters including the housing internal measurements. The only thing they share is length of shaft and outside measurements where the pump fits into the trans cover. Ain't it interesting what we get into ? :yes: So now I have a bake lite pump, with impeller in three pieces and a metal pump with a broker end shaft, that leaves me in need of some pumps, and also leaves me up cooling channel wid out a paddle. :smilie_happy: :smilie_happy: :smilie_happy:

 

[Ansimp]

Least its not hot Mike :smilie_happy:

 

[backlander]

:good: You got it Tony !!!

 

[Steve83]

Now that I think about it, I should have the pump I replaced on the '82, and it's a metal impeller...let me dig around...if I find it, it's yours.

 

[backlander]

Thanks Steve, appreciate it.

 

[backlander]

*Bump* Still need a couple of these pumps if anyone has any laying around. Thanks

 

[Steve83]

Haven't found one yet, but I still have 2 boxes to go through.

 

[backlander]

I know what you mean, all my extra parts are in a mess, I need to get busy and organize this junk.

 

[Steve83]

Well, I'll get it "organized", then get to experimenting, or looking for something, and it's all a mess again! Always needing more storage space...

 

[Ansimp]

Hurry up and find it Steve. I can't wait to see Mikes water pump rebuilding tutorial :good:

 

[backlander]

Already done one Tony, viewtopic.php?f=24&t=4351 Couple things have changed, the kits are still available on Ebay https://www.ebay.com/itm/Water-pump-rebu ... 26&vxp=mtr , no need to remove the impeller from the shaft to install the snap ring in the middle of the shaft, it's not needed, it was only installed to facilitate robotic assembly of the pump so it's a little easier to do now.

 

[dan filipi]

I stickied that rebuild thread.
Good stuff Mike.

 

[backlander]

Thanks, the first one I did is still going strong, no problems as of yet and it's got 5,000 miles on it.

 

[Ansimp]

Thanks Mike. I am pretty sure that will be one of the first jobs on the Aspy when I finally get it home and start playing with it.