Wow tough battle
75 GL1000 "Pete"
- Thread starter pidjones
- Start date
Help Support Classic Goldwings:
OP
OP
Well, I have the new head gasket in hand. And ONE of the idler bearings. I had ordered two at the same time from Amazon, but one came USPS today and the other is setting ~10 miles away at the UPS hub. Bother. Anyway, re-tapped the block, ran the bolts over the wire wheel in the drill press. The idlers are mounted on 10mm x 25mm bolts that I turned the heads on to fit through the holes in the arms with ~2mm flange on the backs. Same as I did on the Hunley. Mounting the idlers using nyloc nuts. The new belts are just looped on right now, until after I get the left head mounted and take the crank back to TDC on #1.
Although the other idler gets in Monday, I doubt there will be any progress next week. Doctor's appointments and jury duty will keep me occupied.
Although the other idler gets in Monday, I doubt there will be any progress next week. Doctor's appointments and jury duty will keep me occupied.
OP
OP
Head mounted and torqued, belts mounted with new idlers, valves adjusted, valve covers installed. Rolled it over upside-down on a furniture dolly for better cleaning and to permit painting tbe bottom. It is strapped to the dolly with ratchet straps that will come off for painting.
- Joined
- Oct 6, 2015
- Messages
- 411
- Reaction score
- 59
- Location
- Holiday, FL
- My Bike Models
- 2022 Harley Sportster 883 (daily), 1986 GL 1200A "Wing Zero"
Unorthodox, but effective.
OP
OP
Unorthodox, that's me. Trying to figure out a very shallow ramp to take it out the garage to the drive out back. There is about a 1.5" drop and a 3" gap full of large gravel at the interface. No issue for a bike, car, etc . but a problem for the small wheels on the dolly. And my shoulder is still an issue.
OP
OP
Work on this project will be put on hold for a while. I need a couple surgeries, and recovery/rehab will take a while.
