I have a 79 GL1000. I am trying to put the master cylinder back together and am not sure which end of the spring goes in first. Does the bigger end go in first, or is it the smaller end? Been too long since I took it apart... :head bang:
Front master cylinder help
- Thread starter PeterDas
- Start date
Help Support Classic Goldwings:
sheesh dont know off hand
[url=https://www.classicgoldwings.com/forum/viewtopic.php?p=120680#p120680:2256npov said:
Yes, one of those things I "forgot", I guess pictures would have been a good idea. I think it goes in big end first, the small end has a covering on it. I think the covering would protect the cup, as the other end is against the case. If I only had my 20 year old memory still......
- Joined
- Dec 3, 2009
- Messages
- 9,291
- Reaction score
- 337
- Location
- Duncanville, Texas
- My Bike Models
- 1981 GL1100 Innerstate("The Turd")SOLD!!, 1996 GL1500 Innerstate
[url=https://www.classicgoldwings.com/forum/viewtopic.php?p=120681#p120681:q988lzpz said:
You are correct, sir.... :yes:
Yup! Big end in first.
Thank you all! I put it in big end first. Now the bleeding begins... The old fashioned way, wrench and hand...
slabghost
Well-known member
Prime the master first. fill reservoir with line off. cover the line hole with your thumb and pump the master slowly until it pushes fluid past your thumb and trys to suck your thumb in. Then hook up the line and bleed.
When you get ready to test system after bleeding down to the caliper... you need to remove one bolt and just loosen the other to allow movement/rotation so that the Bleeder points straight up or is at the top.. this allows that little pocket of air to bleed out..the pad will still grab the rotor this way..
Thank you too all for the great help. I bled the brakes for about 2 hours last weekend, and they are spongy. I will try the advice this weekend as I am riding it to work this week, carefully. They are working, just spongy feeling and need to be bled more. I also noticed I could feel the line moving a little by the caliper banjo fittings as I pump the brakes, and wonder if the inner part of the hose is deteriorated.
- Joined
- Dec 3, 2009
- Messages
- 9,291
- Reaction score
- 337
- Location
- Duncanville, Texas
- My Bike Models
- 1981 GL1100 Innerstate("The Turd")SOLD!!, 1996 GL1500 Innerstate
Get a zip-tie, twine, rope, etc. and pull the lever back, applying the brake, then tie it down like that. Leave it overnight, and see if it don't feel better in the morning. :good:
The hose will normally "swell" with pressure applied, and can cause a spongy feeling....just depends on how much it swells. Braided lines are great upgrades, as they eliminate the hose swelling, and give you a much better brake feel. A little pricey(imo), but well worth it. :yes:
The hose will normally "swell" with pressure applied, and can cause a spongy feeling....just depends on how much it swells. Braided lines are great upgrades, as they eliminate the hose swelling, and give you a much better brake feel. A little pricey(imo), but well worth it. :yes:
I need to put some on my '83. No matter what I've done, the front is still spongy. Maybe I'll name the bike "Bob"...
