One of the few problems with my new GL1000 is that the low beam headlight doesn't work. Has a Vetter fairing. High beam works, and when I put a voltmeter on the low beam terminal with no bulb, it shows just under 12 volts with the engine off, same as the high beam. Tried a different bulb. Tested the headlight by hooking it to a battery with alligator clips, both high and low beams worked. With the headlight hooked up properly, no light, no voltage. I was hoping it was something with the socket, so a round meter probe made contact, but a flat headlight terminal didn't...so I stuck one terminal from the headlight into the low beam socket and measured (with the other two still disconnected) and got voltage.
Where do I check next?
Where do I check next?