Which Tester

Classic Goldwings

Help Support Classic Goldwings:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

badwench

Active member
Joined
Sep 11, 2011
Messages
35
Reaction score
0
Location
Abilene Texas
Was checking on ordering a Sync gauge and carb adjusting tool. Which is the preferred type, gauge or manometer type? would think fluctuation would show less on manometer type. Then again I already have two vacuum gauges and I could just pick two more and get a set of tuner adapters.

Tks
Jim
 
You can use the two gages you have if you build a manifold from aquarium valves. Be sure you check each gage reads the same with the same vacuum source. They can vary a lot.
 
I have the vacuum gauge kit and I an very pleased with it!
 

Attachments

  • Sync 1.JPG
    Sync 1.JPG
    37.6 KB
toytender01":2uwa5zqi said:
I have the same set also. I usually calibrate my gages one at a time using the #3 carb as the source
Very good point BEFORE YOU START! They are easy to calibrate, but if you don't you will have lots of fun with the noises you get at idle and whack yourself on the head after syncing over and over and can't seem to get them right! (Ask me how I know :hihihi: ) :smilie_happy: :smilie_happy:
 

Latest posts

Top