danf
Well-known member
I have an idea in my pea brain, I ran across these sink knob removers at the hardware store, now I have an idea and you guys can shoot it down or approve it if you think it would work, The 80-81's slow jets [idle jets] are pressed in, I have always just used a easy out bit to extract them, well some have had trouble with that.. Looking at this tool if someone were to drill out the hole that it threads down so it just slides up and down you could place a nut on the top of that bar so when you tighten it, it will come straight up without spinning the bolt thing,,,ok for the jet part, just tap down into the jets head about a 1/4" ....the point of the theaded rod you would need to grind it down and use a die to match the tap, screw it down into the jet until it bottoms out and stop, then just turn the nut and out comes your jet..here's a photo...I need someone with an old set of carbs we could test this on..