Search results

Classic Goldwings

Help Support Classic Goldwings:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. GILLT

    What is your favorite cable lube

    Ok, reading up on different cable lube that folks use. Looks like a variety is being used. What's your favorite?(graphite, 3 in 1, grease, spray lube, oil,) what do ya think? :beg: :beg: Need to do some service work on the 83. :yes: :yes:
  2. GILLT

    Little Part Needed

    Trying to fine a small plug that goes in the end of one of the tubes that the back luggage rack sits on. (see pics) Any help or suggestions would be appreciated. Thanks :thanks:
  3. GILLT

    Any Ideas on how to fix

    I have some trim on the fairing that I need to get your ideas on how the best way you have found to re-attach it. What would you use to get it glued in place to stay, or where to find new trim. The stuff at Autozone that I have found is smaller and works for just above the headlight area, but is...
  4. GILLT

    Passanger Foot Rest Tip

    I encountered a problem with the foot rest for the wife. The foot rest where missing the rubber part that sits on the top giving it traction. So I came up with the following. Material needed: Paint, sand, paint brush, masking tape. What I ended up doing first was siffting the sand to get it...
  5. GILLT

    Unknown Cable

    Ok, I was doing some under the false tank, (the three yellow wire solder job) and ran across this cable just before you get to the battery. The cable has a number on it that I think is a #2014. The other end of the cable goes up to the throttle contral next the throttle cable connection. Any...
  6. GILLT

    Switch by Throttle Question

    I was looking at the switch next to the throttle, (off-on-off) and just below are two letters stamped into the switch housing. One is an "H" and the other is a "P". Can anyone tell me what they stand for. :help: Thanks, GILLT
  7. GILLT

    Front Brake Question

    Howdy, I'm needing to replace the resevior for the front brake. What is the best way you have found to remove the (plastic resevior) off to reinstall the new one. Does it just pry off? My replacement is on it's way and should be here in a few days. It is a 83 Goldwing STD. Thanks, GILLT...
  8. GILLT

    Hello from Utah

    Wanted to say hello. Just picked up my first Goldwing about a month ago. An item I can check off of the old (bucket list). It's a 83 GL1100 std. It runs well, and I am looking forward to getting help and informationj from this great site.
Top